Find the shading panel in the Vault.
Adjust the red, green or blue tilt or parabola line shading values.
Note that the Ursa will update 4 lines halfway down the screen. The
update will occur quite slowly. Apply blanking can be
selected to shown a thin area of active video. The height of the lines
can be increased by using Y ASPECT. At this stage you may wish to
increase the brightness control on the wave form monitor to display the
remaining unblanked video.
When the desired shading is found, click on Apply shading.
Wait for between 40sec and 2mins 30 secs until Apply shading
turns off and required shading appears over the whole of the screen.
To return to normal shading either perform an auto align on the URSA
(returns to last saved shading) or close the active list and Apply
shading.
To set a permanent machine shading, adjust as above, then click on Save
in Ursa.
Now whenever an auto align is carried out, this shading will be added
making the align take longer than normal. To return to normal shading,
close the active list and then Save in Ursa and
perform an auto align on URSA. Do not exit from the shading window
whilst applying, this will cause partial shading. If this happens, then
an URSA auto align is needed.
If JumpFree is installed on the telecine then it will need to be
disabled, this is done by moving SW1 bit6 on PCB 102133 towards the
board (down).
The manual shading should be enabled by SW2 bit 3 on PCB 102107,
this is switched to the down position.