Setup of telecine in 625

To set up the telecine timings you will need some film with at least one cut or some numbers.

Ensure the vtr is editing correctly first.
Open the Edit Setup panel.
Set the telecine Preroll to 5 seconds.
Set a suitable IN point on the film so that the chosen frame can easily be recognised when recorded onto tape.
Turn Check Tk sync to Rough.
Perform an edit.
Check to see if the correct film frame has been recorded, ignoring any error messages.
- If the frame has been missed, then the telecine is early and the Runup value must be decreased.
- If it appears on the tape, but after the edit In point, then the telecine is late and the Runup value must be increased.
Repeat until the edit is performed correctly. If inconsistent then check telecine.
Set the Telecine Slip to -9.
Repeat the edit without an OUT point.
- Click on the Telecine Slip while looking at the telecine icon in the bottom right corner of the Platinum screen.
- One value of Telecine Slip will make the telecine reels turn from red to white.
- Stop and check this edit.
Turn Check Tk sync back to Accurate.
Now when editing, no error messages should appear.
Close the Edit Setup panel to save the settings.