The Teranex needs to be put up-stream of the Pixi in the video path.
The version
of Pogle Platinum has to be v521 or greater.
The "/etc/hosts" file will need to have a
"teranex-server" entry; for example:
First, in the "room-setup" panel you must set the noise
reducer type to NONE:
Next, enable the Teranex in the same panel:
Now the Teranex front panel LCD display will change to show the unit is
being controlled remotely. You can now load the "Teranex"
panel (in the Vault)
to control the noise reducer:
Now click on any numerical function and it will be mapped to an encoder
on the Blue/Amber display.
If you do not have an Ethernet controlled Pixi attached to your system
then you will need to temporarily change your SCC Type to
"Pixi/MegaDef" in the "room-setup" panel and save
the new configuration by closing the panel. Now, change the
Control from "RS422" to "Ethernet" in the
"SCC-Setup" panel. Close "SCC-Setup" to save
this new setting, then re-open the "room-setup" and change
back the SCC Type to your current manufacturer. Note: failure to
do this will disable encoder control of the Teranex from the blue/Amber
display, although the function name will still be seen/mapped
underneath the encoder.
Please note that Teranex settings can be programmed but currently it is not possible to perform single frame Teranex corrections or create a dynamic between two Teranex settings. Event duration must be a MINIMUM of 3 frames. This is a known problem with the Teranex software itself.