Setting System defaults

System defaults are used at various times

• To make a live event when a new active list is created
• To make a live event when the current active list is emptied (DELETE ALL ENTER)
• To reset a control to it's default

The same defaults are used for all users. Pixi firmware files contain factory defaults.

Click on Defaults setup in the Engineering panel. This opens the defaults panel.

Clicking on one of the top row of buttons recalls the suggested factory setting. This is not automatically stored. Click on the button below to store the default.

Example: Setting Pixi data to suggested defaults.
Click on Recall factory defaults for secondary.
Click on Save new defaults for secondary.

Example: To set the default varispeed to 20fps.
Type 20 and click on the speed in the Transport panel.
Ensure all other UTILITY values are sensible.
Click on Save new defaults for utility.