Data setup

The current film position in filmcode and frames. The frames display is useful because the Spirit data files have the frame number in their name.

The In point for the data transfer. This is the first frame that will be transfered.

The Out point for the data transfer. This is optional. If present, the data transfer will stop before this frame. If missing, then the transfer will continue until STOP is pressed.

Data preview

In preview mode data will be transfered, but not stored to disk.
Switch into preview in one of two ways

• Select TK and hit STOP to switch to preview mode.
• Select VTR1 and click on EE in the Vtr panel.

Normally the data mode and transfer button should not be touched. They will be set automatically by the Platinum.