in the Room Setup panel.
in the DVNR Setup panel (if you have
a non-AGR4 DVNR).Pandora Revolution Scene Change Detector
in the Room Setup panel.
in the DVNR Setup panel (if you have
a non-AGR4 DVNR).
The Revolution Scene Change Detector works in both video and data
with an appropriate Revolution/Revo Express. However, with a Revo
Express in Datamode, you must start with an EDL list originally grabbed
from the YoYo (usually by hitting Enter). With all other
types of Autoshot (including the PUB rack) you can start with any list.
Pandora Scene Change Detector (Pub Rack)
in the Room Setup panel.
in the DVNR Setup panel (if you have
a non-AGR4 DVNR).
Rank Autoshot
in the Room Setup panel.
in the DVNR Setup panel (if you have
a non-AGR4 DVNR).
DVNR shot detector
in the DVNR Setup panel (if you have a non-AGR4
DVNR).
This overrides the selection in the Room panel.
VS4 shot detector
in the Room Setup panel.
Connect a cable from the VS4 GPI2
connector to the Pogle GPI input connector.
Press the AUTO key to enable scene detection. Now
when playing the source machine in LIVE mode, scenes will be added to
the active event list. If you hold down AUTO the "AUTO" display in the sytem
bar will turn red. This will allow you to add events in PROGRAM
or LIVE modes. Note that with a Revo Express in Datamode, the
AUTO display will always be Red and you must always add events in
Program mode, since they have to be added to an existing EDL list.
Autoshot timing is used to ensure that the events are marked correctly.